Mailing List




You are here: Home > REAR END HOUSINGS > 8.8" Housings
Sort By:
Page of 1
8.8 Ring and pinion
8.8 Ring and pinion
Our Price: $179.00

Ford 8.8 ring and pinion more info
Team Z 8.8" Complete Brace Kit
Team Z 8.8" Complete Brace Kit
Our Price: $270.00

Our Complete Brace Kit come with both the Forward Brace kit and the Bottom Brace to ensure that you get the most support out of your 8.8" housing.  Both kits will limit twisting and bending that may occur with higher horsepower.  The front holes by the pinion must be drilled out to 7/16" to accommodate the hardware for the forward brace.

*PICTURES OF COMPLETE HOUSING DO NOT REPRESENT ACTUAL PARTS IN KIT, NO SHOCK MOUNTS ARE INCLUDED AND MUST BE PURCHASED SEPARATELY!
more info
Team Z Lower Control Arm Instant Center Bracket Slotted
Team Z Lower Control Arm Instant Center Bracket Slotted
Our Price: $209.00

Adjustable lower control arm beacket more info
Team Z Lower Control Arm Instant Center Bracket 4-Hole - Wide 3.00 Axle
Team Z Lower Control Arm Instant Center Bracket 4-Hole - Wide 3.00 Axle
List Price: $139.99
Our Price: $116.00
Current Price: $116.00
You save $23.99!

8.8 lower control arm brackets more info
Team Z 79-04  8.8" Bottom Brace
Team Z 79-04 8.8" Bottom Brace
Our Price: $142.00

Looking to add more support to your 8.8"?  In addition to our forward brace, we offer a weld on under brace for 8.8" housing.  Our kit comes with a pre bent and notched tube to weld to the housing, and a gusset brace to add even more support to the housing.  This kit helps in limiting the axle tubes to bend or move under load and higher horsepower.  Every piece is cut and bent in house. more info
Team Z 79-04 8.8" Forward Brace
Team Z 79-04 8.8" Forward Brace
Our Price: $142.00

Want to add some support to your 8.8" Housing?  We now offer a front brace to add support from your pinion!  Our kit comes weld on tabs that mount to your axle tubes between the control arm brackets, a set of adjustable support bars and hiems, and all the hardware to mount this kit.  You must drill out the holes close to the pinion to 7/16" to fit the bolts to these supports. more info