Designed Specifically For Drag Racing
Rear brake kit for OEM 1967-1980 Small GM housing ends
Fits Strange axles using 1/2" or 5/8" screw-in wheel studs
Compatible with Strange C-clip eliminator kits A1030 or A1034*
Brake offset = 2.832"
* Must specify if using Strange A1032, A1033,or A1100 eliminatorkit
This Strange rear brake kit includes:
Forged One Piece Slotted Steel Rotors
– Superior strength without the concerns of bolts loosening or hats cracking
– Slots improve air flow, assist in warpage prevention, and reduce weight
Four Piston Aluminum Directional Calipers with StainlessSteel Pistons
– Aluminum bodies drastically reduce weight
– Pistons are 1.625" & 1.750" to vary pressure on the pads decreasing padtaper
– Stainless steel pistons are corrosion resistant
– Anti-rattle clips reduce brake pad vibration and noise
Billet Aluminum Caliper Mounts
– One piece design eliminates spacers & bolts that require periodicmaintenance
Modified Inner C-clip Eliminator Halves with Seals &Gaskets
– No pressing required allows for easy installation
– Maintains same wheel to wheel width
– Contains modified half for A1030 / A1034 unless specified otherwise
Hard Metallic Brake Pads
– Provides high resistance to brake fade
– Recommended for vehicles going over 150 MPH in the 1/4 mile
– Maintains decent starting-line cold holding capabilities
– May leave pad residue on rotors that requires removal when pads are changed
Brake hoses and lines are not included
Calipers are tapped 1/8" NPT and supplied with male 3 AN fittings
